Update – We have a new class of “Always-On” batteries for use in projects like this. Also, see our new solar charger kit pages.
I created an automated gardening system called Garduino to monitor soil moisture and automatically water plants, provide supplemental sunlight and warn me when soil temperature drops below 50 degrees Farenheit. Using, Voltaic’s solar panels and battery pack, you can make your Arduino-based gardening even more sustainable by eliminating the need for grid-based power.
Step 1: Parts Tools: Step 2: Create Your Irrigation Tubing Setup Connect irrigation tubing to the sprinkler valve, using soaker hose or sprinkler heads where you’d like water to be emitted. Then, connect the other end of your irrigation tubing to your garden hose. Plumbing tape will help seal up any drips. |
Step 3: Splice Auto Adapter to Connect Multiple Devices Because we’re powering both the sprinkler valve and the Garduino from the Jet Pack battery, we need to splice our adapters together. I chose to cut a male auto adapter and male USB cable to connect both devices to the battery pack. I used a multimeter to determine the positive and negative leads from the male auto adapter. For standard USB cables, red is positive and black is ground. I connected a few LEDs as the lighting; this is only serving as an indicator of how much more time my plants could use light rather than any meaningful supplement. For more serious lighting, you can either connect to a grid-powered outlet as in the original garduino or charge a larger battery and power your lighting with an inverter / 12-volt LED grow light.Once completed, the connections will look like this schematically: |
And like so in the real world: |
Step 4: Attach Solar Panels and Battery Pack Attach your battery pack to the solar panels, set the voltage to 7.2 volts, and plug in the female auto adapter attachment. Here’s what your completed setup should look like, schematically: |
Step 5: Optional Solar Panel Setup If you want to create a more-permanent setup, you can mount your solar panels and add a shelf for the electronics. I used old pallet wood and screws to create this panel mount: |
I also added a plastic bag for water resistance, used 2 wires to extend the photocell to the “roof,” and placed the electronics on the shelf with the sprinkler valve on the ground. I angled the panels to face the sun and can adjust the angle depending on the season. |
Step 6: Garden Away! Good luck garduino-ing, and be sure to share any improvements you make! |
Hello,
Are you still maintaining the arduino project? I’m very much interested on it and would like to exchange some ideas and knowledge. Please Get back at me my email is geniusgrowshop@gmail.com
Kind Regards,
GG
Awesome